Redefining UART ALT Modes For Pinmuxing

This is the place for software discussions not having a dedicated subforum

Redefining UART ALT Modes For Pinmuxing

Postby Must_ba » Sat Mar 25, 2017 12:55 pm

Hello guys;

I am working on to enable Wandboard Quad Uart 2 features for to get data from GPIO3_26 and GPIO3_27 I enabled Uart2 from dts and recompiled imx6q-wandboard.dtb file ,it seems its working but

when I send the "hello" to ttymxc1 I m seeing the senseless charachters , even if I adjust same baudrate ttymxc1 and my machıne ttyUSB0 (I m using usb to rs232 converter ). I think I need to close some features but I dont know what is it or I need to make some configuration pinmuxing and ALT modes .
Is there any way to change the ALT modes of the features or when we choose the UART or another features it is enabling the dependent ALT Mode ?

Can you give me a suggestion or what Am I doing wrong ?

Thanks for all ...

Best Regards

Must_ba
Must_ba
 
Posts: 23
Joined: Thu Jan 19, 2017 11:07 pm

Return to Software - General

Who is online

Users browsing this forum: No registered users and 3 guests

cron