imx6q-wandboard.dts

This is the place for software discussions not having a dedicated subforum

imx6q-wandboard.dts

Postby logicman » Wed Apr 06, 2016 2:21 pm

The technical information about my board is:

Kernel: Linux-3.18.0
board: EDM1+some hardware extensions: EDM1 is an extension of wandboard, imx6q, HannStar display, HSD100pxn1, arm, it is a tablet

I am trying to change imx6qdl.dtsi file to drive LVDS display besides HDMI monitor. HDMI monitor works fine and linux-3.18.0 that is a mainline kernel boots correctly. But lvds panel is completely off and dark. I only see /dev/fb0 and if i force to load imx_ldb.ko no new device will be added!

I wonder what is wrong with my setup? Does LVDS bridge not being driven correctly? or my dts file has a problem?

Thank you for any comment in advance
logicman
 
Posts: 10
Joined: Wed Mar 04, 2015 10:19 am

Re: imx6q-wandboard.dts

Postby upendarpalabindela » Wed Jul 05, 2017 7:05 am

Should I pick one of them (like imx6q-sabresd.dts) and build into .dtb file? If so, could you suggest ... arch/arm/boot/dts/imx6dl-wandboard.dts.
upendarpalabindela
 
Posts: 1
Joined: Wed Jul 05, 2017 7:02 am

Re: imx6q-wandboard.dts

Postby saikrishna » Tue Jul 18, 2017 9:50 am

arch/arm/boot/dts/imx6q-wandboard.dts:17:50: fatal error: dt-bindings/interrupt-controller/irq.h: No such file or directory compilation terminated The same pattern is used for imx6q-wandboard.dts. So, from U-Boot on a WB-Quad you use imxq-wandboard-revb1.dtb for the older B1 board
saikrishna
 
Posts: 1
Joined: Tue Jul 18, 2017 9:46 am


Return to Software - General

Who is online

Users browsing this forum: Yahoo [Bot] and 14 guests

cron